Silverado 96-99 dual exhaust 2.5 SS pipe dual inlet Flowmaster Super 40 RW Tip Side ExitTruck Exhaust Kits
This kit will convert your single exhaust system to a dual exhaust system with a Performance muffler and dual tail pipes on your 1996-1999 Chevrolet Silverado / GMC Sierra 1/2 ton applications. All Wheel Bases. 6 or 8 cyl. Our Kits will convert your single exhaust system to a dual exhaust system with a Performance muffler that will give your truck the look, sound and performance you have been searching for !! Our kits are easy to install , Most jobs take 1 afternoon and basic hand tools . 2 and 3 piece tail pipes make for easy installation.
- Please note : This system is designed to replace your factory OEM exhaust starting from the inlet of the muffler . If your exhaust has been replaced or modified previously fabrication to the existing exhaust on your truck may be necessary for the proper installation of our kit.
- trucks with modified suspension or body lifts may also require fabrication of the exhaust or truck for the proper installation of our kit.
- THIS SYSTEM FITS TRUCKS THAT CAME ORIGINAL WITH A DUAL INLET MUFFLER please double check your application before purchasing.
This kit has 2.5 inch Tail pipes included for increased flow . That equals more power and better fuel economy !
Higher flowing and longer lasting 409 stainless steel mandrel bend pipe is included.
These Super 40 Flowmaster mufflers significantly outflow the older two-chamber mufflers. They help create even more horsepower with less interior noise and a deeper exterior sound. These mufflers feature a design patterned after Flowmaster's race mufflers. These Flowmaster mufflers far exceed older models on Dyno tests. They create a beautiful hot rod sound, along with increased horsepower and gas mileage. So, if you want to get that hot rod sound and add some horsepower, then these Flowmaster mufflers have you covered.
The Rolled edge weld on tips are a chrome plated stainless steel 12" long and 3.5" round . They require a standard wire feed mig welder with regular mild steel wire. A special welder is not required.
This 90 deg exit kit will come out directly behind the rear tire on each side of the truck.