Silverado 96-99 dual exhaust 2.5 SS pipe dual inlet Flowmaster 50 SW Tip Corner exit

Truck Exhaust Kits
SKU:
GF969912SD50SW1245S
$589.99
(No reviews yet) Write a Review
Condition:
New
Current Stock:

This kit will convert your single exhaust system to a dual exhaust system with a Performance muffler and dual tail pipes on your 1996-1999 Chevrolet Silverado / GMC Sierra 1/2 ton applications. All Wheel Bases. 6 or 8 cyl. Our Kits will convert your single exhaust system to a dual exhaust system with a Performance muffler that will give your truck the look, sound and performance you have been searching for !! Our kits are easy to install , Most jobs take 1 afternoon and basic hand tools . 2 and 3 piece tail pipes make for easy installation.

  • Please note : This system is designed to replace your factory OEM exhaust starting from the inlet of the muffler . If your exhaust has been replaced or modified previously fabrication to the existing exhaust on your truck may be necessary for the proper installation of our kit.
  • trucks with modified suspension or body lifts may also require fabrication of the exhaust or truck for the proper installation of our kit.
  • THIS SYSTEM FITS TRUCKS THAT CAME ORIGINAL WITH A DUAL INLET MUFFLER please double check your application before purchasing.

This kit has 2.5 inch Tail pipes included for increased flow . That equals more power and better fuel economy !

Higher flowing and longer lasting 409 stainless steel mandrel bend pipe is included.

Flowmaster's new 50 Series Delta Flow mufflers are designed to produce a mellow, deep sound. They're milder on the outside of the vehicle than the 40 Series mufflers and are significantly quieter on the inside. These mufflers combine the increased horsepower and torque you've come to expect from Delta Flow technology with the performance sound and feel that Flowmaster is famous for.

The Slash Cut weld on tips are a chrome plated stainless steel 12" long and 3.5" round . They require a standard wire feed mig welder with regular mild steel wire. A special welder is not required.

This 45 deg corner exit kit will come out at the corner of the bed below the bumper.